Magno, Julian U.; Honra, Jaime P. (Advisor) ' CFD Analysis and Geometry Optimization of the Wet Steam Multiphase Flow Cyclone Seperator' MSME Thesis, School of Mechanical and Manufacturing Engineering, Mapua University, Manila, Philippines, 2017

Abrasaldo, Robert V.; Manuel, Mark Christian E. (Advisor) 'Design, Fabrication and Performance Evaluation of a Vertical-Cylinder, Semi-Automatic Coconut Dehusker' MSME Thesis, School of Mechanical and Manufacturing Engineering, Mapua University, Manila, Philippines, 2017

Dela Luna, NiÑo Jhim Andrew B.; Manuel, Mark Christian E. (Advisor) ' Tidal Resource Assessment and Hydrodynamic Simulation of a Sea Gen-Type Horizontal Axis Tidal Turbine in Verde Island Passage, Philippines' MSME Thesis, School of Mechanical and Manufacturing Engineering, Mapua University, Manila, Philippines, 2017

Bernardo, Aldrin C.; Isla, Igmedio F. (Advisor) 'Development of Simulation Tool for Electric Vehicle Adoption, Diffusion and Charging Infrastructure Station Based on Agent-Based Model' MSME Thesis, School of Mechanical and Manufacturing Engineering, Mapua University, Manila, Philippines, 2017

Manzano, Joseph M.; Honra, Jaime P. (Advisor) 'Design, Fabrication and Performance Evaluation of Hot Air Dryer Equipped with Rice Husk Fired Furnace (RHFF) and Crossflow Heat Exchanger for Rabbitfish ' MSME Thesis, School of Mechanical and Manufacturing Engineering, Mapua University, Manila, Philippines, 2016

Lopena, Jerome D.; Ang, Edward B.O. (Advisor) 'Development of a Robot for Air-Conditioning Duct System Inspection and Air Quality Measurement' MSME Thesis, School of Mechanical and Manufacturing Engineering, Mapua University, Manila, Philippines, 2016

Nnadiri, Geoffrey Udoka ; Belino, Manuel C. (Advisor); Lopez, Neil A. (Co-Advisor) 'Evaluation of the Drying and Characteristic Curves of Cassava Chips using a Natural Convection Solar Dryer' MSME Thesis, School of Mechanical and Manufacturing Engineering, Mapua University, Manila, Philippines, 2015

Ang, Edward B.; Belino, Manuel C. (Advisor) 'Development of a Low Cost Three Axis Additive Manufacturing Machine' MSME Thesis, School of Mechanical and Manufacturing Engineering, Mapua University, Manila, Philippines, 2014